How to Change DMA Clamps for Different Measuring Modes

METTLER TOLEDO's DMA 1 characterizes materials in the most common deformation modes including:

Three-point bending
Single and dual cantilever
Tension
Compression
Shear

Driveshaft clamps are available for bending/shear and tension/compression modes. This video describes the systematic procedure for changing driveshaft clamps when switching between the different measuring modes.

Related Videos

Automação de análise térmica

Saiba como nossas soluções de automação de análise térmica podem reduzir o esforço e melhorar a eficiência e a reprodutibilidade de seus fluxos de tra...

Tutorial Training on Thermal Analysis

Thermal Analysis (TA) online training course

FlexCal® - cuts calibration and adjustment time to a minimum

Faster Calibration and Adjustment with Thermal Analysis Software

FlexCal® – Thermal Analysis Software Feature Minimizes Calibration and Adjustment Time

DSC curve interpretation training course

DSC Curve Interpretation – A Self-Paced Online Course

This interactive online course on DSC curve interpretation uses clear graphical examples to explain baseline properties, artifacts and their potential...

Online Seminar on Chip-Based Calorimetry

Flash DSC by METTLER TOLEDO revolutionizes chip-based calorimetry through its wide range of heating and cooling rates. This is a very important factor...

Sugestões de pesquisa

How to Change DMA Driveshaft Clamps

Learn How to Easily Switch between a Bending/Shear and Tension/Compression Driveshaft Clamp

Sugestões de pesquisa

How to Change DMA Driveshaft Clamps

Learn How to Easily Switch between a Bending/Shear and Tension/Compression Driveshaft Clamp

Pedido de orçamento ou informaçãoReceber um orçamentoOrçamento instantâneoInformação da SoluçãoRequest Online Demo